... WR-R11a and SB-5000 when connected via radio-controlled Advanced Wireless Lighting would sometimes produce abnormal images. Viewing the WR-R11a Firmware Version:- Connect the WR-R11a to the camera. - Turn the camera on. - Press the camera MENU button and select [Firmware version] in the [SETUP MENU]. - Check the WR-R11a firmware ...
... WR-R11b and SB-5000 when connected via radio-controlled Advanced Wireless Lighting would sometimes produce abnormal images. Viewing the WR-R11b Firmware Version:- Connect the WR-R11b to the camera. - Turn the camera on. - Press the camera MENU button and select [Firmware version] in the [SETUP MENU]. - Check the WR-R11b firmware ...
... f/6.3 VR S lenses, - support for ML-L7 remote controls, - Save focus position and Recall focus ... if a WR-R10 or WR-R11b was used for wireless remote flash photography. - Although focus would normally remain ...
... upgrades can be performed for you by a Nikon-authorized service representative. Viewing the WR-1 Firmware VersionOn the Camera - Attach the WR-1 to the camera and slide the Tx/Rx/OFF switch to Rx. - Turn the camera on. - Press the camera MENU button and select Firmware version ...
... if a WR-R10 or WR-R11b was used for wireless remote flash photography. - Although focus would normally remain locked if the AF-ON button was kept pressed while the shutter-release button was used to take ...
... - Fixed an issue that occurred with WR-R10 wireless remote controller firmware version 3.00. In rare cases, the camera would fail to display the number of exposures remaining or would take about a minute ...
... to stop responding when attached to a WR?R10 wireless remote controller running firmware version 3.00. Updating the Camera Firmware: - Save and run the downloadable file to create a “D810Update” folder. - Using ...
... to stop responding when attached to a WR?R10 wireless remote controller running firmware version 3.00. Updating the Camera Firmware: - Save and run the downloadable file to create a “D810Update” folder. - Using ...
Changes: - The D5 and D500 ISO sensitivity displays are now supported. If you are using two WR-1 units, one as a receiver and the other as a transmitter, update both to firmware version 1.01. - When used as a transmitter to change ISO sensitivity for a receiving camera, the ...